And what other RWC solutions integrate with SharkBite solutions for professional, reliable commercial plumbing installations. Find the line supplying the kitchen and cut out a section of the pipe no longer than 2 inches. Put the blue line into the connector and replace the cover. Fix the clamps on the waterline as you thread it down the back of the unit.
The line under the sink often has a shutoff valve with a male connector. The designated refrigerator line also has a fitting with a male connector. To be able to connect a smooth plastic or copper line to the fittings, you use a female compression nut and ferrule, which is a small tube that fits inside the nut. Once these fittings are in place, you can complete the water hookup to the refrigerator.
Slide a compression nut onto the tubing followed by a ferrule, instructs Ashlee Marie. Tighten the nut by hand, then a bit more with an adjustable wrench. Shut off the cold water under the sink at the supply valve.
How to Hook Up a Water Line to a Refrigerator From the Sink
Turn water on at the sink to run any remaining water out of the line. Attach the copper tube to the valve inlet using a compression nut and sleeve as shown. Finger tighten the compression nut onto valve and then tighten another half turn with a wrench.
Product Key Features
Allow for a ½ inch of space around each side of the refrigerator and one inch between the back of the refrigerator and the wall to help ensure there is proper ventilation. After disconnecting the current refrigerator, remove its contents before moving it. Installing a refrigerator yourself can be done in an afternoon with the help of a friend.
Tighten the fitting by hand, then secure it further using pliers. For the final step in the refrigeration installation process, clean the drawers and shelves and place them back inside the refrigerator. An aligned fridge door helps ensure proper sealing for your appliance.
Leave the unit strapped to the dolly, if it isn’t needed to move other appliances. This will make it easier to unload the refrigerator at the new location. While it also isn’t advisable to transport a refrigerator on its side, this is an option if the move is over a short time or distance. The unit should rest on the side that is opposite from where the compressor lines are installed.
The presence of this water-supply stub-out and shut off valve means there’s an existing connection either through the cabinets or through the floor. Now, you can easily install a water line to your refrigerator using flexible water supply tubes. Moving a refrigerator safely requires planning and help.
Rental Estimate for 9901 E Cork Rd
Locate the ¼ inch copper or PEX water line tubing in the back of the refrigerator. If at any point the refrigerator was tipped on its side, allow it to sit upright for a few hours to allow it to settle before connecting its power supply. Remove all shelves and drawers of the new appliance and tape the doors securely shut or remove them if applicable.
Account
If your refrigerator does not come with leveling legs, refer to your owner’s manual for specific instructions. Turn on the main water supply line to flush out the tubing. I would use a swivel connector and plastic tubing 1/4 inch in diameter. 2 loops for flexibility will not take up too much space. You might want to leave a small gap in the rear for ventilation purposes. The coiling is essential, but I might be inclined toward plastic tubing which is much less prone to a kink.
Loosen the tube clamp on the back of the refrigerator with a screwdriver. This helps prevent damage to the tubing as you move the refrigerator back into TNA Board online position. Pull the refrigerator far enough away from the back wall that you can get behind it. Take care not to damage the floor as you move the fridge.